射芯机在运作之前应该注意6点要求

射芯机在运作之前应该注意以下6点要求：
1、清除妨碍射芯机设备正常运转的障碍物。
2、按润滑卡规定，对设备进行润滑。
3、检查射芯机设备关键部位的紧固件是否紧固，如有松动，必须紧固好。
5、检查全部伐门手柄是否都在静止位置上。
6、拧开压缩空气总伐，对射芯机设备进行空载试车。在这个过程中，要检查机构的动作是否正常， 检查各个伐门的管路是否漏气。
英文版：
The core requirements should be paid attention to 6 requirements before operation.
1, remove obstacles that interfere with the normal operation of the core equipment.
2. Lubricate the equipment according to the lubrication card.
3, check whether the fasteners of the key parts of the core equipment are tight. If there is any loosening, they must be fastened.
5. Check whether all door handles are at rest.
6, unscrew the compressed air total cutting, and carry out the no-load trial run for the core shooting equipment. In this process, check whether the action of the mechanism is normal, check whether the pipeline of each valve is leaking.